Internet Engineering Task Force (IETF) M. Tuexen Request for Comments: 7053 I. Ruengeler Updates: 4960 Muenster Univ. of Appl. Sciences Category: Standards Track R. Stewart ISSN: 2070-1721 Adara Networks November 2013 SACK-IMMEDIATELY Extension for the Stream Control Transmission Protocol Abstract This document updates RFC 4960 by defining a method for the sender of a DATA chunk to indicate that the corresponding Selective Acknowledgment (SACK) chunk should be sent back immediately and should not be delayed. It is done by specifying a bit in the DATA chunk header, called the (I)mmediate bit, which can get set by either the Stream Control Transmission Protocol (SCTP) implementation or the application using an SCTP stack. Since unknown flags in chunk headers are ignored by SCTP implementations, this extension does not introduce any interoperability problems. Status of This Memo This is an Internet Standards Track document. This document is a product of the Internet Engineering Task Force (IETF). It represents the consensus of the IETF community. It has received public review and has been approved for publication by the Internet Engineering Steering Group (IESG). Further information on Internet Standards is available in Section 2 of RFC 5741. Information about the current status of this document, any errata, and how to provide feedback on it may be obtained at http://www.rfc-editor.org/info/rfc7053. Tuexen, et al. Standards Track [Page 1] RFC 7053 SACK-IMMEDIATELY November 2013 Copyright Notice Copyright (c) 2013 IETF Trust and the persons identified as the document authors. All rights reserved. This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License. Table of Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . 2 2. Conventions . . . . . . . . . . . . . . . . . . . . . . . . . . 3 3. The (I)mmediate Bit in the DATA Chunk Header . . . . . . . . . 3 4. Use Cases . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 4.1. Triggering at the Application Level . . . . . . . . . . . . 4 4.2. Triggering at the SCTP Level . . . . . . . . . . . . . . . 4 5. Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . 5 5.1. Sender-Side Considerations . . . . . . . . . . . . . . . . 5 5.2. Receiver Side Considerations . . . . . . . . . . . . . . . 5 6. Interoperability Considerations . . . . . . . . . . . . . . . . 5 7. Socket API Considerations . . . . . . . . . . . . . . . . . . . 5 8. IANA Considerations . . . . . . . . . . . . . . . . . . . . . . 6 9. Security Considerations . . . . . . . . . . . . . . . . . . . . 7 10. Acknowledgments . . . . . . . . . . . . . . . . . . . . . . . . 7 11. References . . . . . . . . . . . . . . . . . . . . . . . . . . 7 11.1. Normative References . . . . . . . . . . . . . . . . . . . 7 11.2. Informative References . . . . . . . . . . . . . . . . . . 7 1. Introduction According to [RFC4960], the receiver of a DATA chunk should use delayed SACKs. This delay is completely controlled by the receiver of the DATA chunk and remains the default behavior. In specific situations, the delaying of SACKs results in reduced performance of the protocol: 1. If such a situation can be detected by the receiver, the corresponding SACK can be sent immediately. For example, [RFC4960] recommends immediately sending the SACK if the receiver has detected message loss or message duplication. Tuexen, et al. Standards Track [Page 2] RFC 7053 SACK-IMMEDIATELY November 2013 2. However, if the situation can only be detected by the sender of the DATA chunk, [RFC4960] provides no method of avoiding a delay in sending the SACK. Examples of these situations include ones that require interaction with the application (e.g., applications using the SCTP_SENDER_DRY_EVENT, see Section 4.1) and ones that can be detected by the SCTP stack itself (e.g., closing the association, hitting window limits, or resetting streams, see Section 4.2). To overcome the limitation described in the second case, this document describes a simple extension of the SCTP DATA chunk by defining a new flag, the "I bit". By setting this bit, the sender of a DATA chunk indicates that the corresponding SACK chunk should not be delayed. 2. Conventions The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in [RFC2119]. 3. The (I)mmediate Bit in the DATA Chunk Header Figure 1 shows the extended DATA chunk. 0 1 2 3 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Type = 0 | Res |I|U|B|E| Length | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | TSN | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Stream Identifier | Stream Sequence Number | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Payload Protocol Identifier | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ \ \ / User Data / \ \ +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ Figure 1: Extended DATA chunk format The only difference between the DATA chunk in Figure 1 and the DATA chunk defined in [RFC4960] is the addition of the I bit in the flags field of the DATA chunk header. Tuexen, et al. Standards Track [Page 3] RFC 7053 SACK-IMMEDIATELY November 2013 [RFC4960] defines the Reserved field and specifies that these bits should be set to 0 by the sender and ignored by the receiver. 4. Use Cases The setting of the I bit can either be triggered by the application using SCTP or by the SCTP stack itself. The following two subsections provide a non-exhaustive list of examples of how the I bit may be set. 4.1. Triggering at the Application Level One example of a situation in which it may be desirable for an application to trigger the setting of the I bit involves the SCTP_SENDER_DRY_EVENT in the SCTP socket API [RFC6458]. Upper layers of SCTP that use the socket API as defined in [RFC6458] may subscribe to the SCTP_SENDER_DRY_EVENT to be notified as soon as no user data is outstanding. To avoid an unnecessary delay, the application can request that the I bit be set when sending the last user message before waiting for the event. This results in setting the I bit of the last DATA chunk corresponding to the user message; this is possible using the extension of the socket API described in Section 7. 4.2. Triggering at the SCTP Level There are also situations in which the SCTP implementation can set the I bit without interacting with the upper layer. If the association is in the SHUTDOWN-PENDING state, setting the I bit reduces the number of simultaneous associations for a busy server handling short-lived associations. Another case is where the sending of a DATA chunk fills the congestion or receiver window. Setting the I bit in these cases improves the throughput of the transfer. If an SCTP association supports the SCTP Stream Reconfiguration extension defined in [RFC6525], the performance can be improved by setting the I bit when there are pending reconfiguration requests that require that there be no outstanding DATA chunks. Tuexen, et al. Standards Track [Page 4] RFC 7053 SACK-IMMEDIATELY November 2013 5. Procedures 5.1. Sender-Side Considerations Whenever the sender of a DATA chunk can benefit from the corresponding SACK chunk being sent back without delay, the sender MAY set the I bit in the DATA chunk header. Please note that why the sender has set the I bit is irrelevant to the receiver. Reasons for setting the I bit include, but are not limited to (see Section 4 for the benefits): o The application requests to set the I bit of the last DATA chunk of a user message when providing the user message to the SCTP implementation (see Section 7). o The sender is in the SHUTDOWN-PENDING state. o The sending of a DATA chunk fills the congestion or receiver window. o The sending of an Outgoing SSN Reset Request Parameter or an SSN/ TSN Reset Request Parameter is pending, if the association supports the Stream Reconfiguration extension defined in [RFC6525]. 5.2. Receiver Side Considerations Upon receipt of an SCTP packet containing a DATA chunk with the I bit set, the receiver SHOULD NOT delay the sending of the corresponding SACK chunk, i.e., the receiver SHOULD immediately respond with the corresponding SACK chunk. 6. Interoperability Considerations According to [RFC4960], the receiver of a DATA chunk with the I bit set should ignore this bit when it does not support the extension described in this document. Since the sender of the DATA chunk is able to handle this case, there is no requirement for negotiating the support of the feature described in this document. 7. Socket API Considerations This section describes how the socket API defined in [RFC6458] is extended to provide a way for the application to set the I bit. Please note that this section is informational only. Tuexen, et al. Standards Track [Page 5] RFC 7053 SACK-IMMEDIATELY November 2013 A socket API implementation based on [RFC6458] needs to be extended to allow the application to set the I bit of the last DATA chunk when sending each user message. This can be done by setting a flag called SCTP_SACK_IMMEDIATELY in the snd_flags field of the struct sctp_sndinfo structure when using sctp_sendv() or sendmsg(). If the deprecated struct sctp_sndrcvinfo structure is used instead when calling sctp_send(), sctp_sendx(), or sendmsg(), the SCTP_SACK_IMMEDIATELY flag can be set in the sinfo_flags field. When using the deprecated function sctp_sendmsg(), the SCTP_SACK_IMMEDIATELY flag can be in the flags parameter. 8. IANA Considerations Following the chunk flag registration procedure defined in [RFC6096], IANA has registered a new bit, the I bit, for the DATA chunk. The "Chunk Flags" registry for SCTP has been updated as described in the following table. DATA Chunk Flags +------------------+-----------------+-----------+ | Chunk Flag Value | Chunk Flag Name | Reference | +------------------+-----------------+-----------+ | 0x01 | E bit | [RFC4960] | | 0x02 | B bit | [RFC4960] | | 0x04 | U bit | [RFC4960] | | 0x08 | I bit | [RFC7053] | | 0x10 | Unassigned | | | 0x20 | Unassigned | | | 0x40 | Unassigned | | | 0x80 | Unassigned | | +------------------+-----------------+-----------+ Tuexen, et al. Standards Track [Page 6] RFC 7053 SACK-IMMEDIATELY November 2013 9. Security Considerations See [RFC4960] for general security considerations for SCTP. In addition, a malicious sender can force its peer to send packets containing a SACK chunk for each received packet containing DATA chunks instead of every other received packet containing DATA chunks. This could impact the network, resulting in more packets sent on the network, or the peer, because the generating and sending of the packets has some processing cost. However, the additional packets can only contain the simplest SACK chunk (no gap reports, no duplicate TSNs), since in cases of packet drops or reordering in the network a SACK chunk would be sent immediately anyway. Therefore, this does not introduce a significant additional processing cost on the receiver side. This also does not result in more traffic in the network, because a receiver sending a SACK for every packet is already permitted. 10. Acknowledgments The authors wish to thank Mark Allmann, Brian Bidulock, David Black, Anna Brunstrom, Gorry Fairhurst, Janardhan Iyengar, Kacheong Poon, and Michael Welzl for their invaluable comments. 11. References 11.1. Normative References [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997. [RFC4960] Stewart, R., "Stream Control Transmission Protocol", RFC 4960, September 2007. [RFC6096] Tuexen, M. and R. Stewart, "Stream Control Transmission Protocol (SCTP) Chunk Flags Registration", RFC 6096, January 2011. 11.2. Informative References [RFC6458] Stewart, R., Tuexen, M., Poon, K., Lei, P., and V. Yasevich, "Sockets API Extensions for the Stream Control Transmission Protocol (SCTP)", RFC 6458, December 2011. [RFC6525] Stewart, R., Tuexen, M., and P. Lei, "Stream Control Transmission Protocol (SCTP) Stream Reconfiguration", RFC 6525, February 2012. Tuexen, et al. Standards Track [Page 7] RFC 7053 SACK-IMMEDIATELY November 2013 Authors' Addresses Michael Tuexen Muenster University of Applied Sciences Stegerwaldstr. 39 48565 Steinfurt DE EMail: tuexen@fh-muenster.de Irene Ruengeler Muenster University of Applied Sciences Stegerwaldstr. 39 48565 Steinfurt DE EMail: i.ruengeler@fh-muenster.de Randall R. Stewart Adara Networks Chapin, SC 29036 US EMail: randall@lakerest.net Tuexen, et al. Standards Track [Page 8]