Network Working Group G. Malkin Request for Comments: 1782 Xylogics, Inc. Updates: 1350 A. Harkin Category: Standards Track Hewlett Packard Co. March 1995 TFTP Option Extension Status of this Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited. Abstract The Trivial File Transfer Protocol [1] is a simple, lock-step, file transfer protocol which allows a client to get or put a file onto a remote host. This document describes a simple extension to TFTP to allow option negotiation prior to the file transfer. Introduction The option negotiation mechanism proposed in this document is a backward-compatible extension to the TFTP protocol. It allows file transfer options to be negotiated prior to the transfer using a mechanism which is consistent with TFTPs Request Packet format. The mechanism is kept simple by enforcing a request-respond-acknowledge sequence, similar to the lock-step approach taken by TFTP itself. While the option negotiation mechanism is general purpose, in that many types of options may be negotiated, it was created to support the Blocksize option defined in [2]. Additional options are defined in [3]. This document assumes reader familiarity with the TFTP specification [1] and its terminology. Packet Formats TFTP options are appended to the Read Request and Write Request packets. A new type of TFTP packet, the Option Acknowledgment (OACK), is used to acknowledge a client's option negotiation request. A new error code, 8, is hereby defined to indicate that a transfer should be terminated due to option negotiation. Malkin & Harkin [Page 1] RFC 1782 TFTP Option Extension March 1995 Options are appended to a TFTP Read Request or Write Request packet as follows: +-------+---~~---+---+---~~---+---+---~~---+---+---~~---+---+--> | opc |filename| 0 | mode | 0 | opt1 | 0 | value1 | 0 | < +-------+---~~---+---+---~~---+---+---~~---+---+---~~---+---+--> >-------+---+---~~---+---+ < optN | 0 | valueN | 0 | >-------+---+---~~---+---+ The "0"s shown in these illustrations and the ones below are all all zero octets, i.e., NULL terminators for the preceeding fields. opc The opcode field contains either a 1, for Read Requests, or 2, for Write Requests, as defined in [1]. filename The name of the file to be read or written, as defined in [1]. This is a NULL-terminated field. mode The mode of the file transfer: "netascii", "octet", or "mail", as defined in [1]. This is a NULL-terminated field. opt1 The first option, in case-insensitive ASCII (e.g., "blksize"). This is a NULL-terminated ASCII field. value1 The value associated with the first option, in case-insensitive ASCII. This is a NULL-terminated field. optN, valueN The final option/value pair. Each NULL-terminated field is specified in case-insensitive ASCII. The options and values are all NULL-terminated, in keeping with the original request format. If multiple options are to be negotiated, they are appended to each other. The order in which options are specified is not significant. The maximum size of a request packet is 512 octets. Malkin & Harkin [Page 2] RFC 1782 TFTP Option Extension March 1995 The OACK packet has the following format: +-------+---~~---+---+---~~---+---+---~~---+---+---~~---+---+ | opc | opt1 | 0 | value1 | 0 | optN | 0 | valueN | 0 | +-------+---~~---+---+---~~---+---+---~~---+---+---~~---+---+ opc The opcode field contains a 6, for Option Acknowledgment. opt1 The first option acknowledgment, copied from the original request. value1 The acknowledged value associated with the first option. If and how this value may differ from the original request is detailed in the specification for the option. optN, valueN The final option/value acknowledgment pair. Negotiation Protocol The client appends options at the end of the Read Request or Write request packet, as shown above. Any number of options may be specified; however, an option may only be specified once. The order of the options is not significant. If the server supports option negotiation, and it recognizes one or more of the options specified in the request packet, the server may respond with an Options Acknowledgment (OACK). Each option the server recognizes, and accepts the value for, is included in the OACK. Some options may allow alternate values to be proposed, but this is an option specific feature. The server must not include in the OACK any option which had not been specifically requested by the client; that is, only the client may initiate option negotiation. Options which the server does not support should be omitted from the OACK; they must not cause an ERROR packet to be generated. If the value of a supported option is invalid, the specification for that option will indicate whether the server should simply omit the option from the OACK, respond with an alternate value, or send an ERROR packet, with error code 8, to terminate the transfer. An option not acknowledged by the server must be ignored by the client and server as if it were never requested. If multiple options were requested, the client must use those options which were acknowledged by the server and must not use those options which were not acknowledged by the server. Malkin & Harkin [Page 3] RFC 1782 TFTP Option Extension March 1995 When the client appends options to the end of a Read Request packet, three possible responses may be returned by the server: OACK - acknowledge of Read Request and the options; DATA - acknowledge of Read Request, but not the options; ERROR - the request has been denied. When the client appends options to the end of a Write Request packet, three possible responses may be returned by the server: OACK - acknowledge of Write Request and the options; ACK - acknowledge of Write Request, but not the options; ERROR - the request has been denied. If a server implementation does not support option negotiation, it will likely ignore any options appended to the client's request. In this case, the server will return a DATA packet for a Read Request and an ACK packet for a Write Request establishing normal TFTP data transfer. In the event that a server returns an error for a request which carries an option, the client may attempt to repeat the request without appending any options. This implementation option would handle servers which consider extraneous data in the request packet to be erroneous. Depending on the original transfer request there are two ways for a client to confirm acceptance of a server's OACK. If the transfer was initiated with a Read Request, then an ACK (with the data block number set to 0) is sent by the client to confirm the values in the server's OACK packet. If the transfer was initiated with a Write Request, then the client begins the transfer with the first DATA packet, using the negotiated values. If the client rejects the OACK, then it sends an ERROR packet, with error code 8, to the server and the transfer is terminated. Once a client acknowledges an OACK, with an appropriate non-error response, that client has agreed to use only the options and values returned by the server. Remember that the server cannot request an option; it can only respond to them. If the client receives an OACK containing an unrequested option, it should respond with an ERROR packet, with error code 8, and terminate the transfer. Malkin & Harkin [Page 4] RFC 1782 TFTP Option Extension March 1995 Examples Read Request client server ------------------------------------------------------- |1|foofile|0|octet|0|blksize|0|1432|0| --> RRQ <-- |6|blksize|0|1432|0| OACK |4|0| --> ACK <-- |3|1| 1432 octets of data | DATA |4|1| --> ACK <-- |3|2| 1432 octets of data | DATA |4|2| --> ACK <-- |3|3|<1432 octets of data | DATA |4|3| --> ACK Write Request client server ------------------------------------------------------- |2|barfile|0|octet|0|blksize|0|2048|0| --> RRQ <-- |6|blksize|0|2048|0| OACK |3|1| 2048 octets of data | --> DATA <-- |4|1| ACK |3|2| 2048 octets of data | --> DATA <-- |4|2| ACK |3|3|<2048 octets of data | --> DATA <-- |4|3| ACK Security Considerations Security issues are not discussed in this memo. References [1] Sollins, K., "The TFTP Protocol (Revision 2)", STD 33, RFC 1350, MIT, July 1992. [2] Malkin, G., and A. Harkin, "TFTP Blocksize Option", RFC 1783, Xylogics, Inc., Hewlett Packard Co., March 1995. [3] Malkin, G., and A. Harkin, A., "TFTP Timeout Interval and Transfer Size Options", RFC 1784, Xylogics, Inc., Hewlett Packard Co., March 1995. Malkin & Harkin [Page 5] RFC 1782 TFTP Option Extension March 1995 Authors' Addresses Gary Scott Malkin Xylogics, Inc. 53 Third Avenue Burlington, MA 01803 Phone: (617) 272-8140 EMail: gmalkin@xylogics.com Art Harkin Internet Services Project Information Networks Division 19420 Homestead Road MS 43LN Cupertino, CA 95014 Phone: (408) 447-3755 EMail: ash@cup.hp.com Malkin & Harkin [Page 6]